FujiFilm FinePix E900 - Disconnecting the Printer; Connecting to a PC

5
6
Q} Press "4" or '1_-" to display the frame (file) for
which you want to specify PRINT settings.
@ Press 'A" or "_" to set a value up to 99 as the
number of copies of the frame (file) to be printed.
For frames (files) that you do not want printed,
set the number of prints to 0 (zero).
To specify more PRINT settings, repeat steps Q}
and @.
_3)Always press the "MENU/OK" button after the
settings are completed.
_* Movies andimages with CCD-RAWcannot be printed.
(/_Images photographedwith a camera other than FinePix E900
may not be printed.
"PRINT OK?" appears on the LCD monitor. Press
the "MENU/OK" button to begin printing.
The "Connecting to a PC" section explains how to connect the camera to your PC using the USB
cable (mini-B) and describes the functions you can use once the camera and PC are connected.
Refer to Section 5 the first time you connect the camera to your PC.
Install the software first. Do not connect the camera to the PC before installing
all the software.
CD-ROM
(Software for FinePix CX)
I _]_ DSC (Mass storage device) mode I
This mode provides a simple way to read images from an xD-Picture Card and store images onto
an xD-Picture Card.
7
I_ 1/9SHEETS
NmD
[] []
[3[3[3
Printer starts printing the specified number of
prints.
_Press the "DISPiBACK" button to cancel the printing.
Depending on the printer, the printing may not be canceled
immediately or printing may stop midway through. When
printing stops midway, briefly turn the camera off and then on
again.
AC-3VX
USB cket (minFB)
Q}Check that 'PRINTING" is not displayed on the
camera's screen.
@Turn the camera off. Unplug the USB cable
(mini-B).
<
¢e
108 109