6.3 Running the Getting Started Wizard
d. Select Use the following IP Address and then enter the following information:
Depending on the configuration you may need to reset the network
settings to their original state later. Therefore keep in mind or write
down the current settings before you make any changes.
l IP address – 10.17.21.200
l Subnet mask – 255.255.255.0
e. Click OK.
f. Wait for the computer to set the IP addresses on the local computer.
6.3 Running the Getting Started Wizard
6.3.1 Login, Welcome, License Agreement
See "Supported Browsers" on page 122 for information about the browsers
supported by the ETERNUS CS800 Web GUI.
Proceed as follows:
1. On the notebook:
a. Open a supported Web browser.
b. Type 10.17.21.1 in the Address box.
Press <Enter>.
The Login page displays (see figure below).
If the Login page does not display, verify that you entered the correct IP
address (10.17.21.1) and that the network settings on the computer are
correct. Wait five minutes, then try again. If the Login page still does not
display, contact Fujitsu Technology Solutions.
ETERNUS CS800 102
To Next Page
Loading...
