15.2 Common Problems and Solutions
15.2.3 Ethernet Network Problems
The table below describes corrective actions for problems occurring with the Ethernet
network.
Problem Corrective Action
The Ethernet link light on the
ETERNUS CS800 is not lit when
a cable is connected to a hub
or switch.
Check to make sure the Ethernet cable is not a cross-over
cable. Use only "straight" CAT-6 Ethernet cables.
Port on the hub or switch is not active or damaged.
Port on the ETERNUS CS800 is damaged. Contact the
Fujitsu Technology Solutions Customer Support
department (see "Support and Help" on page 12).
The Ethernet link light on the
switch or hub is not lit when a
cable is connected to ETERNUS
CS800 system.
Check to make sure the Ethernet cable is not a cross-over
cable. Use only "straight" CAT-6 Ethernet cables.
Port on the hub or switch is not active or damaged.
Port on the ETERNUS CS800 is damaged. Contact the
Fujitsu Technology Solutions Customer Support
department (see "Support and Help" on page 12).
ETERNUS CS800 system is not
visible on the Ethernet
network.
Try to ping the ETERNUS CS800 system IP address from a
host on the same network. If the ping reports round trip
times, the ETERNUS CS800 system is active. If not, check
the cables, switches, or hubs for damaged components. If
everything checks out, contact the Fujitsu Technology
Solutions Customer Support department (see "Support
and Help" on page 12).
ETERNUS CS800 remote
management pages are not
visible.
If you cannot connect to the ETERNUS CS800 remote
management pages, make sure your browser is
configured properly, e.g. check its proxy settings. Check if
the ETERNUS CS800 is visible on the network in general
(see above). As far as available, check firewall and proxy.
Contact the Fujitsu Customer Support department (see
"Support and Help" on page 12)
ETERNUS CS800 436
To Next Page
Loading...
