Fujitsu ETERNUS CS800 S6 - ETERNUS DX100 S3 Base Module - Rear View

3.2 Storage Modules
LED name LED status Description
POWER green DC power is supplied to the controller enclosure.
IDENTIFY blue blinking The installation location of the controller enclosure is
identified according to the instruction that is issued from
ETERNUS Web GUI or ETERNUS CLI.
FAULT amber The system is in error status.
blinks amber A part of the ETERNUS DX requires preventive
maintenance.
MAINTENANCE green Maintenance for the ETERNUS DX is in progress.
blinks green Maintenance or a status check via ETERNUS Web GUI or
ETERNUS CLI is necessary.
CACHE green There is data in the cache memory of the ETERNUS DX.
READY green The ETERNUS DX is available for use..
Table 12: Status and Meanings of Each LED (Operation Panel - Base Module)
For detailed information on ETERNUS DX100 S3 storage module see ETERNUS DX100 S3
storage module manuals.
3.2.4 ETERNUS DX100 S3 Base Module - Rear View
This chapter describes the rear view of ETERNUSDX100 S3 base module, which includes
connectors and indicators.
Figure 36: Rear view of DX100 S3 controller enclosure
ETERNUS CS800 62