Fujitsu ETERNUS CS800 S6 - Reboot & Shutdown

14.7 Reboot & Shutdown
If you decide not to install the software upgrade after uploading it, click Remove
to remove the current upload from the ETERNUS CS800.
Clear Your Web Browser Cache
It is important to clear your Web browser cache before logging on to the remote
management console for the first time following the software upgrade. This will ensure
the remote management console displays correctly.
14.7 Reboot & Shutdown
The Reboot & Shutdown page allows you to reboot or shut down the ETERNUS CS800.
To access the Reboot & Shutdown page, click the Utilities menu, and then click the Reboot
& Shutdown tab (see "Reboot & Shutdown Page" on page 430).
CAUTION!
Before shutting down the ETERNUS CS800, make sure that all backup and replication
jobs are finished, and that space reclamation activity is complete.
Figure 303: Reboot & Shutdown Page
To reboot or shutdown the ETERNUS CS800:
1. Under System Action, select an option:
Reboot Reboots the ETERNUS CS800.
Rebooting the system closes the Web browser
connection. You must log on again after the system
has rebooted.
Shutdown Shuts down the ETERNUS CS800.
Reset from diagnostic state (Only available when the node is in degraded mode)
Restarts the services on the node without rebooting
the system.
2. Click Apply.
ETERNUS CS800 430