10.9 System
To set the system date and time:
1. Select one of the following options:
Option Description
Network Time Protocol (NTP)
Server
(Recommended) Select this option to synchronize the
ETERNUS CS800 with an NTP timeserver or pool. Then
select or specify a timeserver or pool.
l Select a Timeserver Pool - (Recommended)
Select one of the well-known, geographically-
based NTP timeserver pools in the drop-down
box.
To select a timeserver pool, you must first specify
at least one DNS IP address on the Network page
(see "Network" on page 293). Otherwise, you
must specify the IP address of the timeserver
pool.
l Specify a Timeserver or Pool - Type the name or
IP address of the NTP server or pool. (See
http://support.ntp.org for information about
publicly available NTP servers)
To verify that the ETERNUS CS800 can communicate
with the NTP server or pool, click Test NTP.
Manual Date & Time Settings Select this option to manually set the system date
and time.
Specify the New System Date by clicking the calendar
icon. Specify the New System Time using the drop-
down boxes.
2. In the Timezone drop-down box, select the time zone where the ETERNUS CS800 is
located.
3. Next to Time Format, select the format to use when displaying times (24 hours or 12
hours).
4. Click Apply.
10.9.3 Security
The Security page allows you to configure security settings for the ETERNUS CS800,
including access passwords, LDAP/AD, SSL settings, and the inactivity timeout.
To access the Security page, click the Configuration menu, and then click the Security tab.
The Security page contains the following tabs:
ETERNUS CS800 308
To Next Page
Loading...
