Fujitsu ETERNUS CS800 S6 - Network Configuration

6.3 Running the Getting Started Wizard
6.3.3 Network Configuration
Figure 80: Network Configuration
Using the Network page, each physical Ethernet port in the ETERNUS CS800 can be
configured as a separate device. In addition, you can create bonded devices (logical ports)
consisting of two or more physical ports of the same link speed (1GbE or 10GbE). For each
port or device, you can specify the MTU (Maximum Transmission Unit) frame size.
After you define devices (single port or bonded), you can create up to ten network
interfaces for each device. Each interface has its own IP address information. In addition,
you can configure the following options for each interface:
ETERNUS CS800 106