16.1 ETERNUS CS800 S6 Hardware
Figure 308: 2.5-inch HDD Numbering
16.1.2 HDD Removal and Replacement Procedures
Removing
1. Release the locking mechanism by pressing the locking button (1).
2. Push the handle of the HDD module fully in the direction of the arrow (2).
The HDD module is now unlocked.
3. Wait about 30 seconds to allow the hard disk drive to spin down.
4. Pull the HDD module completely out of its bay (see the figures below).
Figure 309: Disconnecting a 2.5-inch HDD
ETERNUS CS800 445
To Next Page
Loading...
