Fujitsu ETERNUS CS800 S6 - Physical Device Discovery

10.6 PTT Configuration
Additional Information
l Path to tape is available only on the ETERNUS CS800 Multi-Protocol configuration.
l For information about working with storage servers and LSUs, see "OST Configuration"
on page 227.
l For detailed information about configuring and using OST path to tape, see the
ETERNUS CS800 NetBackup and Backup Exec OST Configuration Guide .
l OST path to tape options can only be configured when the OST and Backup
Application Specific licenses have been enabled.
To access the PTT page, click the Configuration menu, and then click the PTT tab.
The PTT page contains the following tabs:
l "Physical Device Discovery" on page 261
10.6.1 Physical Device Discovery
The Physical Device Discovery page allows you to discover attached physical tape libraries
and tape drives. After you discover the libraries and drives, you can use them for path to
tape data movement.
To access the Physical Device Discovery page, on the PTT page, click the Physical Device
Discovery tab (see "Physical Device Discovery Page" on page 261).
Figure 181: Physical Device Discovery Page
The Physical Device Discovery page displays the following information for all discovered
physical libraries and tape drives:
ETERNUS CS800 261