11.4 Receive VTL
11.4 Receive VTL
The Receive VTL page allows you to manage incoming replication activity for VTL
partitions. You can recover a replicated partition on the target system if the source system
is unavailable. Once the source system becomes available, you can failback the partition
to make it available on the source system again.
Before you can receive replicated partitions, you must specify one or more
replication sources (see "Adding a Replication Source" on page 259).
To access the Receive VTL page, click the Replication menu, and then click the Receive >
VTL tab.
Tasks
Use the Receive VTL page to perform the following tasks:
l View received snapshots and recover, failback, or delete snapshots (see "Received
Snapshots" on page 367).
l Manage recovery jobs (see "Recovery Jobs" on page 372).
l Manage failback jobs (see "Failback Jobs" on page 373).
l Manage shares configured for Cartridge Based Replication (see "Cartridge Based" on
page 374).
Received Snapshots
The Received Snapshots page allows you to view and work with received snapshots. When
a replicated VTL partition is received from a source system, it is saved as a snapshot. The
snapshot contains all of the data necessary to fully recover or failback the partition to the
point in time when the snapshot was saved.
To access the Received Snapshots page, on the Receive VTL page, click the Received
Snapshots tab (see "Received Snapshots Page" on page 368).
ETERNUS CS800 367
To Next Page
Loading...
