8.3 VTL Wizard
Figure 107: VTL Wizard: Add Media
Step 4: Discover Remote Hosts
1. Click Discover Remote Hosts to list all hosts that are known to the ETERNUS CS800
(see "VTL Wizard: Discover Remote Hosts" on page 145).
A host is made known to the ETERNUS CS800 if you enter the host ID on this page, or if
the host logs on to one or more Fibre Channel target ports.
If you do not see the world wide name (WWN) of the host, make sure the host is
connected to a Fibre Channel port on the ETERNUS CS800 and click Discover Remote
Hosts again.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system.
An Active status indicates the host is currently logged on to one or more Fibre
Channel target ports.
2. Enter information about the host:
Remote Host WWPN Enter the World Wide Port Name (WWPN) of the host.
Alias Enter a descriptive alias for the host
3. Click Apply.
4. (Optional) To discover additional hosts, repeat Steps 1–3.
5. Click Next to continue.
ETERNUS CS800 144
To Next Page
Loading...
