8.5 Replication Wizard
The Sync ID is used to identify the source partition that will send replicated data to
the target partition. The Sync ID must be identical to the Sync ID of the source
partition on the source system.
b. If you enabled Cartridge Based Replication, select an Access option:
Locked The partition is not allowed to receive new
Cartridge Based Replication data.
Unlocked The partition is allowed to receive new Cartridge
Based Replication data.
You cannot configure a partition to both send and receive Cartridge Based
Replication data.
4. Click Apply.
5. (Optional) To configure additional partitions for replication, repeat Steps 1–4.
6. Click Next to continue.
Figure 119: Replication Wizard: VTL Partitions
Step 5: Confirm
1. Review the settings you selected to make sure they are correct. If necessary, click
Previous to return to a previous step to make changes (see "Replication Wizard:
Confirm" on page 158).
2. After you have confirmed all settings, click Finish. The wizard configures the ETERNUS
CS800 with the settings you selected.
ETERNUS CS800 157
To Next Page
Loading...
