10.2 NAS Configuration
Allow all users/hosts to access
this share
(NFS or CIFS/SMB shares only) Select this check box to
allow all hosts (NFS shares) to access the share.
Or clear the check box to allow only specified users or
hosts to access the share. To add a user or host to the
access list, click Add. Specify the Hostname or IP
Address (NFS shares) and the associated permissions
(Read Only or Read & Write), and then click Apply.
Additional Information
l To modify the users that are available in the
Workgroup User list, see "Share Access" on page
198.
l After you add a user or host to the access list,
you cannot change their permissions. Instead,
select the user or host in the access list and click
Delete to remove them from the list. Then add
the user or host again with the correct
permissions.
3. (Optional) Under Replication Settings, specify replication settings.
For more information about configuring replication for a share, or to set up
replication for the share at a later time, see "Replication" on page 340.
4. Click Apply.
If you modify a NAS share that uses the CIFS/SMB protocol, you must restart the
CIFS/SMB service for the changes to take effect. To restart the CIFS/SMB service,
first disjoin the Windows workgroup, then join it again (see "Windows Domain"
on page 195). Restarting the CIFS/SMB service will close all active connections to
the share. Most Windows workstations will automatically reconnect, but some
applications may be affected.
Deleting a NAS Share
Delete a NAS share if it is no longer needed. When you delete a share, all data stored on
the share is lost, and any schedules associated with the share are deleted.
If you delete a share configured for Directory/File Based Replication on the
source ETERNUS CS800, the share is not automatically deleted on the target
ETERNUS CS800. If you do not want to retain the share on the target ETERNUS
CS800, you can manually delete it.
To delete a NAS share:
ETERNUS CS800 194
To Next Page
Loading...
