10.3 VTL Configuration
Library Model Select the library model emulated by the partition.
The library model determines the inquiry string
returned to the host by the ETERNUS CS800. (The
library model does not restrict the number of slots or
drives in a partition because library emulation is not
a representation of a physical library.)
The following library models are available:
l Fujitsu CS-TL
l ADIC Scalar 100, ADIC Scalar i2000, or ADIC Scalar
i500
l ADIC Pathlight VX
Number of Storage Slots Enter the number of storage slots in the partition (up
to 9,000).
One I/E slot is created for each storage slot up
to a maximum of 240 I/E slots.
Virtual Tape Drive Model Select the tape drive model emulated by the virtual
drives in the partition. All virtual tape drives in a
partition must be the same model.The following tape
drive models are available:
l IBM LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
l HP LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
Number of Virtual Tape Drives Enter the number of virtual tape drives in the
partition.
If all tape drives are currently assigned to other
partitions, you must remove one or more tape
drives from an existing partition to make them
available for use in a new partition.
Enable deduplication - Select the check box to enable data deduplication.
Fujitsu Technology Solutions recommends that you
enable data deduplication to optimize disk usage.
Data deduplication is enabled by default. You
cannot enable or disable data deduplication
after the partition is added. If data duplication
is disabled, then data compression is also
disabled.
ETERNUS CS800 208
To Next Page
Loading...
