10.3 VTL Configuration
Figure 153: Media Actions Page
To perform actions on virtual tape cartridges:
1. In the Partition drop-down box, select the partition that contains the cartridges to
work with.
Select UNASSIGNED to work with cartridges that are not assigned to any
partition.
The table displays the following information for all virtual tape cartridges in the
partition:
Barcode The barcode number of the cartridge.
Type The cartridge type.
Partition The partition where the cartridge is located.
WP The write protect status of the cartridge (Write
Enabled or Write Protected).
ETERNUS CS800 214
To Next Page
Loading...
