Fujitsu ETERNUS CS800 S6 - Page 242

10.4 OST Configuration
You must configure at least one remote user before you can enable
Automatic Image Replication (see "Manage Remote Users" on page 245).
5. If Automatic Image Replication is enabled, select the replication target you want to
replicate images to. (You can select only a single target.) When images are replicated,
data will be sent to the selected target.
6. If Automatic Image Replication is enabled, specify the following information:
Remote Storage Server Name The name of the remote storage server (on the target
ETERNUS CS800) to replicate data to. The source
ETERNUS CS800 and target ETERNUS CS800 must
reside in different NetBackup domains.
To configure the target ETERNUS CS800, see
"Replication Send" on page 347.
Remote LSU Name The name of the LSU in the remote storage server
that will receive the replicated data.
Remote User The OST user credentials to use for authentication on
the remote (target) ETERNUS CS800. The selected
remote user must match a local user on the
Configuration > OST > Manage Users page on the
target ETERNUS CS800 (see "Manage Users " on page
331).
7. Click Apply.
Editing an LSU
Edit an LSU to change its capacity, description, or automatic image replication settings.
To edit an LSU:
1. Select the LSU and click Edit.
The Edit Logical Storage Unit page displays (see "Edit Logical Storage Unit Page" on
page 243).
ETERNUS CS800 242