10.5 Replication Configuration
Deleting a Replication Target
Delete a replication target if the ETERNUS CS800 no longer needs to send replicated data
to that target. After the target system is deleted, the ETERNUS CS800 will no longer send
replicated data to that system.
When a target is deleted:
l All replication jobs to that target that are in progress or queued will transition to
failed.
l All replication job history for that combination of target and share or partition is
removed.
l All shares or partitions will be reconfigured to no longer replicate to that target..
To delete a replication target:
1. Under Target System, select one or more targets to delete.
2. Click Pause to pause replication to the target.
3. Click Delete.
The deleted target is not automatically removed from existing replication
schedules. You must edit scheduled events to remove the deleted target (see
"Scheduler" on page 262).
Pausing or Resuming Replication to a Target
The source ETERNUS CS800 controls the replication pause behavior.
l To pause replication, select a target under Target System and click Pause. The
ETERNUS CS800 temporarily stops sending replicated data to the selected target.
l To resume replication, select a target under Target System and click Resume. The
ETERNUS CS800 resumes sending replicated data to the selected target.
Enabling System Throttling
Enable system throttling to limit the network bandwidth used for replication to all targets.
When a constant throttle is enabled, the ETERNUS CS800 limits the amount of data it
sends during source replication so that it does not exceed the specified bandwidth.
Additional Information
l If multiple targets are configured, replication to all targets counts against the same
bandwidth limit.
l To vary the replication throttle rate over time, use the Configuration > Scheduler page
(see "Scheduler" on page 262). Do not enable a constant throttle if a throttle schedule
is configured. The scheduled replication throttling bandwidth settings take precedence
over the constant throttle value. (The currently active replication throttle rate appears
on the Home page under Current Activity.)
To enable system replication throttling:
ETERNUS CS800 257
To Next Page
Loading...
