10.9 System
Figure 206: Network Page: Interface Details
1. If necessary, click the Show link to show the interface details table.
2. For each device, select the MTU (Maximum Transmission Unit) frame size in the Jumbo
Frame MTU Size drop-down box.
1500 MTU (Default) The standard (STD) MTU frame size of 1,500
bytes is used.
9000 MTU The jumbo MTU frame size of 9,000 bytes is used. (For
best performance, make sure the entire network path
to the ETERNUS CS800 is configured to use 9000
MTU.)
3. Click Update to save the changes you made to the Interface Details table. (Clicking
Update does not yet apply the new network settings to the ETERNUS CS800.)
4. Click Undo to revert to all current Interface Details changes to the last update.
Configuring Interface IP Addresses
Under IP Address Configuration > IP Address Table, configure one or more network
interfaces for each port or device (physical Ethernet port or bonded device) (see "Network
Page: IP Address Table" on page 300):
ETERNUS CS800 299
To Next Page
Loading...
