Fujitsu ETERNUS CS800 S6 - Page 301

10.9 System
ETERNUS CS800, and the ETERNUS CS800 is externally identified by the host IP. The
following restrictions apply:
l You can designate only one external host IP for the network configuration.
l You must specify a traffic type of Mgmt (management) or Any for the external
host IP interface.
l You must specify a valid Default Gateway in the General section. In addition, the
external host IP must be on the same subnet as the Default Gateway to ensure
external communication.
4. Enter the following network information as provided by your network administrator
(all fields are required):
IP Address The IP address of the interface.
Netmask The network mask of the interface.
Gateway The gateway of the ETERNUS CS800. (This is usually
not the same as the default gateway.)
5. If necessary, specify NAT (Network Address Translation) settings for the interface:
If the ETERNUS CS800 is a replication target and is behind a NAT router, you
must configure a NAT IP Address.
NATed Select the check box if the IP address of the ETERNUS
CS800 is translated by a firewall to a NAT IP address
when the ETERNUS CS800 communicates to the
outside world.
NAT IP Address The IP address used to access the ETERNUS CS800
from the public network. The router that connects the
ETERNUS CS800 to the Internet performs Network
Address Translation that maps the IP address of the
ETERNUS CS800 to the NAT IP address, providing a
valid replication interface for a source ETERNUS
CS800.
6. Select the check box for each type of network traffic allowed on the interface
(segmentation):
At least one interface must allow management traffic.
Mgmt Select to allow management traffic.
Repl Select to allow replication traffic.
Data Select to allow data traffic.
Any Select to allow all types of traffic (management,
replication, and data).
ETERNUS CS800 301