10.9 System
d. Click OK.
The key is removed from the Available SSH Public Keys table.
3. In addition to configuring SSH authentication, the SSH service account may also be
configured with password authentication.
l Select the Allow login with password check box to enable a password on CLI
service account
l Clear the Allow login with password check box to disable a password on CLI
service account
Enter the following information:
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
l Passwords can be up to 20 characters. Alphanumeric characters and special
characters are allowed.
l For accounts enabled with both SSH and password authentication, the ETERNUS
CS800 system will first attempt SSH authentication. If there are no keys defined or
no client key matches, the ETERNUS CS800 system will fall back to password
authentication.
4. Click Apply.
LDAP/AD
The LDAP/AD page allows the ETERNUS CS800 system to connect to a Lightweight Directory
Access Protocol (LDAP) or Active Directory (AD) server.
Lightweight Directory Access Protocol (LDAP) stores information about users and groups
in a hierarchical directory composed of organizational units (OUs), object classes, and
attributes. Microsoft Active Directory (AD) stores information about Users and Groups. The
ETERNUS CS800 can use LDAP/AD to authenticate user credentials and assign access levels
to the system.
ETERNUS CS800 319
To Next Page
Loading...
