3.1 Server
Figure 9: Front panel indicators and buttons
The table below describes each item.
Item Indicator, Button, Port Description
1 Reset button Pressing the Reset button reboots the system. It can be
pressed using the end of a paper clip.
CAUTION!
Risk of data loss!
2 NMI button This button is used to troubleshoot software and device
driver errors. It can be pressed using the end of a paper
clip.
CAUTION!
Do not press! Risk of data loss! The NMI button may
only be used by service.
3 ID indicator /
ID button
The ID button highlights the ID indicator on the front and
I/O panels for easy server identification.
The ID indicator lights up blue on the front and on the rear
of the server when the ID button is pressed. Both ID
indicators are synchronized.
ETERNUS CS800 41
To Next Page
Loading...
