5.2 Installing the components in the rack
Figure 56: Locating the mounting position
2. Push the M5 cage nuts into the 2nd holes of the front rack pillars above the base line
of the storage module (1). Push further M5 cage nuts into the 5th holes too (2).
Figure 57: Inserting the Cage Nut
3. Attach the support bracket to the left rear rack pillar, see "Fitting the Support Bracket"
on page 80.
4. Insert the pins of the left slide rail in the 1st and 3rd holes from the bottom of the
support bracket (see 1 in figure "Inserting the Pins of the Left Slide Rail" on page 86 ).
ETERNUS CS800 85
To Next Page
Loading...
