Fujitsu ETERNUS DX60 S3 - RAID Group Management

Appendix B Factory Default List
B.4 RAID Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
1004
B.4 RAID Group Management
This section provides information on the default parameters of the following actions for RAID group
management.
• Create RAID Group
• Rename RAID Group
• Change Controlling CM
• Expand RAID Group
• Modify RAID Group Parameters
• Assign Eco-mode Schedule (RAID Group)
• Set Key Group (RAID Group)
■ Create RAID Group
*1: The default value varies depending on the type of drives that are installed in the ETERNUS DX and that can be used
to create new RAID groups.
■ Rename RAID Group
■ Change Controlling CM
Screen Setting item Default value
New RAID Group Create Mode Automatic
Automatic Setting Drive Type Online (*1)
RAID Level High Performance (RAID1+0)
Select Drives Minimize number of using drives
Manual Setting RAID Level High Performance (RAID1+0)
Controlling CM Automatic
Fast Recovery Configuration
• When the RAID level is "RAID6-FR"
(3D+2P)x2+1HS
• When the RAID level is not "RAID6-FR"
Blank
Checkbox to select a drive All cleared
Advanced Settings Stripe Depth 64 KB
Screen Setting item Default value
Rename Setting Start of Suffix 0
Screen Setting item Default value
Change Controlling CM Setting New Controlling CM Automatic