Fujitsu ETERNUS DX60 S3 - Setup Power Management

Chapter 1 System Management
1.4 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
48
4 Click the [Done] button to return to the [System Settings] screen.
End of procedure
1.4.8 Setup Power Management
This function connects the external device and controls (shuts down) the ETERNUS DX power.
For details on the parameters for this function, refer to "A.1.3.7 Setup Power Management" (page 678)
.
For the factory default settings for this function, refer to "Appendix B Setup Power Management" (page 974)
.
The procedure to perform power management setting is as follows:
Procedure
1 Click [Setup Power Management] in [Action].
2 Specify the parameters.
■ For the ETERNUS DX8700 S3/DX8900 S3
If this function is enabled by mistake, the ETERNUS DX may shut down unexpectedly. Make sure to check
setting contents before performing settings.