Fujitsu ETERNUS DX60 S3 - Setup E-Mail Notification

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
130
1.8.12 Setup E-Mail Notification
This function is used to configure the mail notification settings for the various events detected by the ETERNUS
DX.
To specify event notification, refer to "1.9.1 Setup Event Notification" (page 144)
.
For details on the parameters for this function, refer to "A.1.7.10 Setup E-Mail Notification" (page 717)
.
For the factory default settings for this function, refer to "Appendix B Setup E-Mail Notification" (page 982)
.
The procedure to set a E-Mail notification is as follows:
Procedure
1 Click [Setup E-Mail Notification] in [Action].
2 Specify the parameters.
When stopping the event notification via E-Mail, perform one of the following procedures.
• Disable the "Notification E-Mail"
• Clear the E-Mail checkbox of the notification method using the procedure in "1.9.1 Setup Event
Notification" (page 144).