Fujitsu ETERNUS DX60 S3 - Test Server Connectivity

Chapter 1 System Management
1.14 Remote Support Management (AIS Connect)
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
211
The procedure to send log is as follows:
Procedure
1 Click [Send Log] in [Action].
 A confirmation screen appears.
2 Click the [OK] button.
 Sending log starts.
3 Click the [Done] button to return to the screen when starting this function in Step 1.
End of procedure
1.14.4 Test Server Connectivity
This function checks the connection status between the ETERNUS DX and a remote server (AIS Connect server).
This function collects logs (including I/O Module logs) at the time when performing the [Send Log] function.
Log files are divided into 640MB increments and sent to the AIS Connect server.
Checking the connection status is only available when "AIS Connect" is enabled. Refer to "1.14.1 Setup AIS
Connect Environment" (page 206) for details.
This function checks the connection status of the AIS Connect server by using the AIS Connect information in
the ETERNUS DX. After performing the procedure in "1.14.1 Setup AIS Connect Environment" (page 206)
, use
the [Test Server Connectivity] function to check the connection status.