Fujitsu ETERNUS DX60 S3 - Delete Key Group; Modify Key Group

Chapter 1 System Management
1.11 Key Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
174
1.11.6 Delete Key Group
This function deletes the key group.
The procedure to delete a key group is as follows:
Procedure
1 Click [Delete Key Group] in [Action].
 A confirmation screen appears.
2 Click the [OK] button.
 Deleting of the key group starts.
3 Click the [Done] button to return to the [Key Group] screen.
End of procedure
1.11.7 Modify Key Group
This function changes the key group settings.
The key group combines all of the RAID groups that use the same key.
For details on the parameters for this function, refer to "A.1.10.5 Modify Key Group" (page 757)
.
The procedure to change the key group settings is as follows:
Procedure
1 Click [Modify Key Group] in [Action].
A key group in which RAID groups are registered cannot be deleted. Use the [SED Key Group] screen to check
whether RAID groups are registered in the key group. Refer to "SED Key Group" in "ETERNUS Web GUI User’s
Guide (Operation)" for details.