Fujitsu ETERNUS DX60 S3 - Delete Eco-Mode Schedule; Modify Eco-Mode Schedule

Chapter 1 System Management
1.6 Eco-mode Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
80
1.6.3 Delete Eco-mode Schedule
This function deletes the Eco-mode schedule.
The procedure to delete an Eco-mode schedule is as follows:
Procedure
1 Select the schedule that is to be deleted (multiple selections can be made) and click [Delete
Schedule] in [Action].
 A confirmation screen appears.
2 Click the [OK] button.
 Deletion of the Eco-mode schedule starts.
3 Click the [Done] button to return to the [Eco-mode] screen.
End of procedure
1.6.4 Modify Eco-mode Schedule
This function modifies the Eco-mode schedule.
Up to eight events can be specified for a single Eco-mode schedule.
• An Eco-mode schedule that is allocated to a RAID group cannot be deleted.
• An Eco-mode schedule that is allocated to a Thin Provisioning Pool cannot be deleted.
Disk operation time varies depending on the Eco-mode schedule settings and disk access.
A disk is spun up even if it is outside of disk operation time in the following conditions:
• If disk access occurs while the disk motor is stopped:
The disk is immediately spun up and can be accessed within 1 - 5 minutes.
• If a disk is activated more than a set amount of times in a day:
A state of increased access frequency is assumed and the Eco-mode will cease stopping the disk motor.