Fujitsu ETERNUS DX60 S3 - Appendix H Storage Migration Setting Files; Template File for Storage Migration Settings

ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
1074
Appendix H
Storage Migration Setting Files
This appendix describes Storage Migration setting files.
H.1 Template File for Storage Migration Settings
The following table shows the details of a template file for storage migration settings.
Keyword Number of
settings
Allowed input
Type Specify the type of Storage Migration.
(Example) Type = Open
1Open
GROUP Specify a path group for each source storage system.
Up to 16 path groups can be specified.
Specify "0x" (2-digit) + 0 - F (1-digit) with hexadecimal
numbers.
[Example] GROUP=0x0
10x0 - 0xF
("0x" + 1-digit hexadecimal)
OPE-
MODE
Specify one of the operation modes (M/M+QC/
M+FC/QC/FC) for the Storage Migration.
The following symbols are used for the operation
modes:
M: Migration
M+QC: Migration + Quick Compare
M+FC: Migration + Full Compare
QC: Quick Compare
FC: Full Compare
OPEMODE can be omitted. When this parameter is
not specified, "Migration" is used.
Refer to "Operation mode" (page 1076)
for details.
[Example] OPEMODE=M+QC
1M
M+QC
M+FC
QC
FC