Fujitsu ETERNUS DX60 S3 - CA Port Group Management; Create FC Port Group

Chapter 4 Connectivity Management
4.3 CA Port Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
429
4.3 CA Port Group Management
This section describes CA port group management.
CA Port Group management provides the following functions:
• Create FC Port Group
• Create iSCSI Port Group
• Create SAS Port Group
• Create FCoE Port Group
• Delete CA Port Group
• Modify CA Port Group
• Modify FC Port Parameters
• Modify iSCSI Port Parameters
• Modify SAS Port Parameters
• Modify FCoE Port Parameters
• Modify Port Mode
4.3.1 Create FC Port Group
This function creates a new FC port group, and registers the port to be a member.
An FC port group is a group of FC-CA type ports that are connected to the specified host group. The Host
Affinity is specified for each FC port group.
• The maximum number of port groups per storage system is 128 (with a maximum number of 384 for the
ETERNUS DX8700 S3/DX8900 S3), irrespective of the CA types.
• The maximum number of ports per port group is 8.
• A port can be a member of several port groups.