Fujitsu ETERNUS DX60 S3 - Create NAS Interface

Chapter 4 Connectivity Management
4.8 NAS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
508
4.8.4 Create NAS Interface
This function creates NAS interfaces. Up to 160 NAS interfaces can be created.
This function is used in a Unified Storage environment.
For details on the parameters for this function, refer to "A.4.7.3 Create NAS Interface" (page 890)
.
For the factory default settings for this function, refer to "Appendix B Create NAS Interface" (page 1002)
.
The procedure to create a NAS interface is as follows:
Procedure
1 Click [Create] in [Action].
2 Specify parameters for the NAS interface
If the NAS interface creation has not been completed successfully, wait for the ETERNUS DX S3 series status to
return to normal and then try again.
To use the Active-Active connection, specify different IP addresses on the same subnetwork for the ports of
each CM that will be duplicated.