Fujitsu ETERNUS DX60 S3 - Delete Controller Firmware Schedule

Chapter 1 System Management
1.15 Firmware Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
224
1.15.2 Delete Controller Firmware Schedule
This function deletes the application schedule for the controller firmware.
If any of the following conditions occur, the reservation for deleting the schedule is automatically canceled.
• The application schedule for the controller firmware is reserved
- Rebooting of the ETERNUS DX
- Power failure or power recovery
- Machine down recovery
- The system time in the ETERNUS DX is changed to a time that is later than the reserved time
• Start time to apply the controller firmware
- Other users perform system settings
- Pinned data exists in the ETERNUS DX
• The start time to apply controller firmware (when the application mode is "Update")
- The storage system is not in normal status
- The battery status is not "Full Charge"
- REC sessions with the following conditions appear
• A blocked copy path is being used and the session status is not "Suspend" or "Error Suspend"
• The mirror status of the REC buffer that is being used is "Recovering" and the session status is not
" Suspend" or " Error Suspend"
- A storage migration path exists
- RAID Group Expansion (LDE) is being used
- A volume is being encrypted
• When the application schedule for the controller firmware is specified, the start time is displayed in the
information field. Refer to "Firmware Maintenance" in "ETERNUS Web GUI User’s Guide (Operation)" for
details.
• When controller firmware is applied, the application schedule can be set. Refer to "1.15.1 Apply Controller
Firmware" (page 215) for details.