Fujitsu ETERNUS DX60 S3 - System Management; Modify Storage System Name

Chapter 1 System Management
1.4 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
32
1.4 System Management
This section describes system management.
System management provides the following functions:
• Modify Storage System Name
• Modify Date and Time
• Change Box ID
• Setup Subsystem Parameters
• Setup Encryption Mode
• Setup SMI-S Environment
• Register SED Authentication Key
• Setup Power Management
• Setup Extreme Cache
• Setup Exclusive Read Cache
• Setup Disk Drive Patrol
• Setup Debug Mode
1.4.1 Modify Storage System Name
This function registers the name, administrator, and the installation site of the ETERNUS DX.
Information registered in this screen is used for the following functions and screens:
• Network management using Simple Network Management Protocol (SNMP)
• Storage system name displayed in the login screen and the operation screens
For details on the parameters for this function, refer to "A.1.3.1 Modify Storage System Name" (page 667)
.
The procedure to change the storage system name is as follows:
Procedure
1 Click [Modify Storage Name] in [Action].
Once the storage system name has been specified, it cannot be deleted (it can be changed).