Fujitsu ETERNUS DX60 S3 - Setting Example of the Storage Migration Setting File

Appendix H Storage Migration Setting Files
H.3 Setting Example of the Storage Migration Setting File
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
1079
H.3 Setting Example of the Storage Migration Setting File
A setting example of the Storage Migration setting file is shown below:
The above example describes the case where the following paths and migration volumes are configured for
three source storage systems (GROUP#0, 1, 2).
# Setting Example (for the for the ETERNUS DX60 S3/DX100 S3/DX200 S3, the ETERNUS DX500 S3/DX600 S3,
# and the ETERNUSDX200F)
eternus-storage-migration-0101
Type=Open
GROUP=0
OPEMODE=M+QC
{
PATH=CM0,CA0,P0,0000000011111111
PATH=CM1,CA0,P1,2222222233333333
VOL=0x0000,0x0040
VOL=0x0001,0x0041
VOL=0x00FF,0x013F
}
GROUP=1
OPEMODE=M+QC
{
PATH=CM0,CA1,P0,8888888888888888
VOL=4,10
}
GROUP=2
OPEMODE=M
{
PATH=CM0,CA1,P1,9999999999999999
VOL=0x0000011000000000,0x0141
}