Fujitsu ETERNUS DX60 S3 - Modify Threshold Thin Provisioning Pool

Chapter 6 Thin Provisioning Pool Management
6.8 Modify Threshold Thin Provisioning Pool
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
580
6.8 Modify Threshold Thin Provisioning Pool
This function changes the threshold for monitoring the used capacity of Thin Provisioning Pool. There are two
types of threshold: "Warning" and "Attention".
For details on the parameters for this function, refer to "A.6.5 Modify Threshold Thin Provisioning Pool" (page
933).
For the factory default settings for this function, refer to "Appendix B Modify Threshold Thin Provisioning Pool"
(page 1007).
The procedure to change the threshold of a TPP is as follows:
Procedure
1 Select the TPP for which the threshold is to be changed (multiple selections can be made)
and click [Modify Threshold] in [Action].
2 Select a new threshold.
• This function changes the threshold of a TPP that is created by using the procedure in "6.2 Create Thin
Provisioning Pool" (page 559).
• Using this function enables setting the same threshold to multiple TPPs with a single operation.
• Changes in the usage status of a TPP can be notified. The following statuses can be notified. Refer to
"1.9.1 Setup Event Notification" (page 144)
for details.
- From " Normal" to " Attention"
- From " Normal" or " Attention" to " Warning"
- The TPP capacity is exhausted