Fujitsu ETERNUS DX60 S3 - Page 678

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
678
A.1.3.6 Setup SMI-S Environment (for Controller Firmware Version V10L2x or earlier)
For details about this function, refer to "1.4.6 Setup SMI-S Environment" (page 43).
For the factory default settings for this function, refer to "Appendix B Setup SMI-S Environment" (page 973)
.
● Set SMI-S
• SMI-S
A.1.3.7 Setup Power Management
For details about this function, refer to "1.4.8 Setup Power Management" (page 48).
For the factory default settings for this function, refer to "Appendix B Setup Power Management" (page 974)
.
● Power Control by External Device
• RCIL
• Auto Power
• Power Resume
Description Select whether to "Enable" or "Disable" the SMI-S function.
Input condition/
Display contents
• Enable
• Disable
Description Select whether to "Enable" or "Disable" the RCIL connection.
Input condition/
Display contents
• Enable
• Disable
Description Select whether to "Enable" or "Disable" the power interlock mode (the function to
automatically power on when the power is supplied).
When PMAN is connected, enable the "Auto Power".
When the power synchronized unit is connected, disable the "Auto Power".
Input condition/
Display contents
• Enable
• Disable
Description Select whether to "Enable" or "Disable" the auto power recovery mode (the function to
automatically power on at power recovery after a power failure).
Input condition/
Display contents
• Enable
• Disable