Fujitsu ETERNUS DX60 S3 - Page 118

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
118
For details on the parameters for this function, refer to "A.1.7.6 Setup SNMP Agent User" (page 713).
For the factory default settings for this function, refer to "Appendix B Setup SNMP Agent User" (page 981)
.
The procedure to set the user to access the SNMP Agent is as follows:
Procedure
1 Click [Setup SNMP User] in [Action].
2 When adding a user, click the [Add] button. Click the [User Name] link to edit the user.
 The [Setup SNMP Agent User] screen appears.
The authentication and encryption can be enabled/disabled, and also the MIB access range can be specified,
for each user.
To delete the existing user, click the [Delete] button for the target user.