Fujitsu ETERNUS DX60 S3 - Page 145

Chapter 1 System Management
1.9 Event/Dump Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
145
2 Specify whether to notify each event.
■ Setting based on Severity (for the ETERNUS DX8700 S3/DX8900 S3)
■ Setting based on Severity (for the other models)
• The events are classified into three levels: "Error Severity Level", "Warning Level", and
"Informational Level".
Click the [Setting based on Severity] tab, [Error Severity Level] tab, [Warning Level] tab or
[Informational Level] tab to display the setting fields for each level.
• Event notifications can be reset to the default state. Click the [System Defaults] button to display
the default state and click the [Set] button. For the settings, refer to "Initial state list" (page 741)
.
• When setting the REMCS recommended pattern, click the [REMCS Defaults] button to display the
REMCS recommended pattern and click the [Set] button. For the settings, refer to "REMCS
recommended pattern list" (page 745).
• For the ETERNUS DX8700 S3/DX8900 S3, the notification methods that are specified in this
function determine whether to display the LCD message on the Overview screen and the Operation
Panel.