Fujitsu ETERNUS DX60 S3 - Page 147

Chapter 1 System Management
1.9 Event/Dump Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
147
■ Informational Level
3 Click the [Set] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Setting of the event notification starts.
5 Click the [Done] button to return to the [Event/Dump] screen.
End of procedure
• The following events have been changed from " Error Severity Level" to " Informational
Level" in the [Setup Event Notification] function of the controller firmware version V10L30 or later.
- Automatic Change Storage Cluster Active/Standby State
- Manual Change Storage Cluster Active/Standby State
• If the controller firmware version is updated from V10L2x to V10L30 or later, the event notification
settings (whether to notify and the notification method) that were set in V10L2x are retained.
• Threshold of SDP usage can be specified using the procedure in "7.7 Modify Copy Parameters"
(page 608).
• Threshold of copy table size usage can be specified using the procedure in "7.6 Modify Copy Table
Size" (page 602).
• If free space of an ODX Buffer volume is insufficient, expand the volume capacity. For details, refer
to the following sections:
- "3.5 Expand Volume" (page 278)
- "3.7.1 Expand Thin Provisioning Volume" (page 285)
- "3.9 Start RAID Migration" (page 301)