Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
424
2 Input new host information.
The main setting items are as follows.
● FC/FCoE Host Setting
• Name
• WWN
• Host Response
3 Click the [Modify] button
A confirmation screen appears.
4 Click the [OK] button.
Changing of the FC host information starts.
• The range of LUNs that can be recognized from the host are determined by the "LUN Addressing"
settings and the "LUN Expand Mode (Peripheral Device Addressing)" settings for the host
response. Before changing a host response, check the LUN setting state. If LUNs that are LUN#256
onward are used, the recognizable LUN setting cannot be changed to a "256 LUN" host response.
Refer to "Host responses and recognizable LUNs" (page 818)
for details.
• If an error screen appears under the following conditions, check the parameter settings.
- The "Name" is not entered
- The "Name" does not satisfy the input conditions
- The "Name" already exists
- The "WWN" is not entered
- The "WWN" does not satisfy the input conditions
- The same "WWN" is already registered in the ETERNUS DX
- There are some LUNs that cannot be recognized from the FC host because the "Host Response"
setting has been changed (only for FC hosts that are not registered in a host group)
To Next Page
Loading...
