Fujitsu ETERNUS DX60 S3 - Page 530

Chapter 5 RAID Group Management
5.1 Create RAID Group
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
530
For details on the parameters for this function, refer to "A.5.1 Create RAID Group" (page 903).
For the factory default settings for this function, refer to "Appendix B Create RAID Group" (page 1004)
.
There are two methods to create a volume: automatic drive selection and manual drive selection.
■ Automatically selecting drives to create RAID groups
The procedure to create a RAID group is as follows:
Procedure
1 Click [Create] in [Action].
2 Select "Automatic" for "Create Mode".
3 Specify the RAID group detailed information.
The main setting items are as follows.
● New RAID Group
• Name
• For the ETERNUS DX60 S3, SSDs and SEDs cannot be used for configuring a RAID group.
• "Striping (RAID0)" has no data redundancy. The use of "High Performance (RAID1+0)", "High Capacity
(RAID5)", "High Reliability (RAID6)", "High Reliability (RAID6-FR)", "Reliability (RAID5+0)", or "Mirroring
(RAID1)" is recommended.