Fujitsu ETERNUS DX60 S3 - Page 640

Chapter 7 Advanced Copy Management
7.8 REC Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
640
2 Click the [Measure] button.
 Measurement of round trip time starts.
3 Change the "Round Trip Time (msec)" value if necessary.
The main setting item is as follows.
● Measure Round Trip Time
• Round Trip Time (msec)
4 Click the [Modify] button
 A confirmation screen appears.
5 Click the [OK] button.
 The round trip time measurement result is updated in the ETERNUS DX.
• If the round trip time has not been entered, the [Modify] button cannot be clicked.
• If the entered round trip time does not satisfy the input conditions, an error screen appears. If this
occurs, check the parameter settings.