Fujitsu ETERNUS DX60 S3 - Page 698

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
698
A.1.6.2 Modify RADIUS
For details about this function, refer to "1.7.3 Modify RADIUS" (page 90).
For the factory default settings for this function, refer to "Appendix B Modify RADIUS" (page 977)
.
● RADIUS Setting
• RADIUS Authentication
• Recovery Mode
Description Select whether to "Enable" or "Disable" RADIUS Authentication.
Input condition/
Display contents
• Enable
Use RADIUS Authentication.
• Disable
Use the internal authentication.
Description When "Enable" has been specified in the "RADIUS Authentication" field, select the
desired operation if RADIUS Authentication fails.
If RADIUS Authentication fails when "No" has been selected for "Recovery Mode", logging
on to ETERNUS Web GUI will not be available.
Selecting "Yes" is recommended.
Input condition/
Display contents
• Yes (Communication error / Authentication error)
When communication with the RADIUS server fails or communication with the
RADIUS server succeeds but authentication fails, internal authentication is
performed.
• Yes (Communication error)
When communication with the RADIUS server fails, internal authentication is
performed.
• No
Even when communication with the RADIUS server fails, or communication with the
RADIUS server succeeds but authentication fails, internal authentication is not
performed.