Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
730
• Drive Error of HDD Shield
• Succeeded HDD Shield
• Temperature Error
• End of battery life
• Rebuild/Copyback w/ redundant
Description Select whether to notify when a failure occurs in a protected (shielded) drive for each
condition that is described below. When notifying, select the notification method.
• Any Time
Notifies always when a failure occurs in a protected (shielded) drive.
• when HS<0
Notifies only when a failure occurs in a protected (shielded) drive while available hot
spare disk is " 0" (*1).
*1: When rebuilding cannot be performed because there are no hot spares that can be
used as a substitute for the failed drive.
When the SNMP trap setting is changed from "OFF" to "ON", a message is displayed in the ETERNUS SF event log.
Description Select whether to notify when a failed drive is diagnosed as being available by the
protect (shield) function and is activated in the ETERNUS DX. When notifying, select the
notification method.
When the SNMP trap setting is changed from "OFF" to "ON", a message is displayed in the ETERNUS SF event log.
Description Select whether to notify when a temperature error status is detected by the sensor. When
notifying, select the notification method.
Description Select whether to notify when a battery expires. When notifying, select the notification
method.
"End of battery life" notification is available only for the ETERNUS DX500 S3/DX600 S3
and the ETERNUS DX8700 S3/DX8900 S3.
Description Select whether to notify when rebuilding or copy backing (with redundancy) (*1) is
performed. When notifying, select the notification method.
*1: "Rebuilding to hot spare disk is complete", "Copyback starts" and "Copyback
complete" are equivalent to "Redundancy".
To Next Page
Loading...
