Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
734
● Warning Level
Select whether to notify of a warning event for each event type.
The input conditions and the display contents for the warning level are as follows:
• Parts Warning
• Drive Warning
• Drive Warning of HDD Shield
Input condition/
Display contents
Checkbox
• Selected
Notify
• Cleared
Not notify
• -
Not applicable to notification
Description Select whether to notify when a warning level event occurs in a part other than the drive.
When notifying, select the notification method.
Description Select whether to notify when a warning level event occurs in a non-protected (non-
shielded) drive for each condition that is described below. When notifying, select the
notification method.
• Any Time
Notifies always when a warning level event occurs in the drive.
• when HS<0
Notifies only if a warning level event occurs in the drive when available hot spare
disk is "0" (*1).
*1: When rebuilding cannot be performed because there are no hot spares that can be
used as a substitute for the failed drive.
Description Select whether to notify when a warning level event occurs in a protected (shielded)
drive for each condition that is described below. When notifying, select the notification
method.
• Any Time
Notifies always when a warning level event occurs in a protected (shielded) drive.
• when HS<0
Notifies only when a warning level event occurs in a protected (shielded) drive
failure while available hot spare disk is "0" (*1).
*1: When rebuilding cannot be performed because there are no hot spares that can be
used as a substitute for the failed drive.
When the SNMP trap setting is changed from "OFF" to "ON", a message is displayed in the ETERNUS SF event log.
To Next Page
Loading...
