Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
773
A.1.12.4 Setup Log Sending Parameters
For details about this function, refer to "1.13.5 Setup Log Sending Parameters" (page 201).
For the factory default settings for this function, refer to "Appendix B Setup Log Sending Parameters" (page
986).
● Send Log based on Events
• Send Log when Errors Occur
● Send Log Periodically
• Periodical Transmission of Log
• Time
• Period
Description To send logs automatically in the case of a failure, select the "Send" checkbox.
The default state of "Send Log when Errors Occur" setting will be changed to "Send" if the
Remote Support setting using the [Setup Remote Support] function has been completed.
Input condition/
Display contents
"Send" checkbox
• Selected
• Cleared
Description To send log periodically, select the "Enable" checkbox.
The default state of "Periodical Transmission of Log" will be changed to "Enable" if the
Remote Support setting using the [Setup Remote Support] function has been completed.
Input condition/
Display contents
"Enable" checkbox
• Selected
• Cleared
Description Specify the time when sending logs periodically.
A time between "10:00" and "15:00" is set for the default setting. (*1)
*1: Different days and times are specified in the factory settings in order to disperse
the load on the REMCS center.
Input condition/
Display contents
• Numeric characters
• 00 - 23
Hour
• 00 - 59
Minute
• Undefined (10:00 - 15:00)
Different times are specified in the factory settings.
Description Specify the period when sending logs periodically.
Input condition/
Display contents
• Once per Week
• everyday
To Next Page
Loading...
