Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
844
• Frame Size
• Reset Scope
• Release Reservation if Chip is Reset
• REC Line No.
Description Select the frame size (bytes) of the target port.
"Frame Size" specifies the length of the communication information.
Input condition/
Display contents
• 512
• 1024
• 2048
Description Specify the reset scope of the target port.
Reset scope is the range where the command reset request from the server is performed,
when the target port is connected to multiple servers.
Input condition/
Display contents
• I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset
request.
• T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to the
port.
This item is displayed when the port mode is "CA" or "CA/RA".
Description Select whether to "Enable" or "Disable" the function to release the reserved status of the
volume when the target port (chip) is reset.
Input condition/
Display contents
• Enable
• Disable
This item is displayed when the port mode is "CA" or "CA/RA".
Description Select the REC line number of the target port.
The REC line number is used to switch the communication path when a line fails. The
REC line number is used to recognize failed lines. Set different REC line numbers for each
physical communication path. When lines are in normal status, an REC can be performed
regardless of the REC line number (specifying the same REC line numbers is allowed) in
the same way as conventional REC operations. Note that no priority applies to REC line
numbers.
This item is displayed only when the Advanced Copy license has been registered.
To Next Page
Loading...
