Fujitsu ETERNUS DX60 S3 - Page 861

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
861
● Additional IP Address Information
• Additional IP Address Settings
- Multiple VLAN
- VLAN ID
- IP Version
Description Select whether to "Enable" or "Disable" the Multiple VLAN settings for the target port.
When the Multiple VLAN setting is enabled, multiple IP addresses can be specified
for a single iSCSI-CA port. This enables concurrent connection to multiple hosts that
belong to different VLANs via a single iSCSI-CA port.
Input condition/
Display contents
• Enable
• Disable
• This item is displayed when the port mode is "CA" or "CA/RA".
• If the Multiple VLAN setting is changed to "Disable", all of the added IP address information is deleted.
When the port mode is "CA" or "CA/RA" and Multiple VLAN is enabled, multiple IP address information
can be specified.
Description Select whether to "Enable" or "Disable" the VLAN ID for IP#n (n: 1 - 15).
When "Enable" is selected, input the VLAN ID.
Input condition/
Display contents
• Enable
Specify the VLAN ID between 0 and 4095
• Disable
Description Select the IP version for IP#n (n: 1 - 15).
Input condition/
Display contents
• IPv4
Specify the IPv4 address. When "IPv4" is selected, input "IP Address" (required),
"Subnet Mask" (required), and "Gateway".
• IPv6
Specify the IPv6 address. When "IPv6" is selected, input "IPv6 Connect ID Address"
(required), "IPv6 Global Address", and "IPv6 Gateway".
• IPv4/IPv6
Specify both the IPv4 address and the IPv6 address. The input items for IPv4 and
IPv6 can be specified.