Fujitsu ETERNUS DX60 S3 - Page 873

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
873
• NACA
• Device ID Type
• Product ID
● Test Unit Ready Command Settings
• Reservation Conflict Response
● Sense Settings
• Notify Change of Volume Mapping
• Notify Change of Volume Expansion
Description Select "Enable" or "Disable (Default)" for the Normal Auto Contingent Allegiance (NACA)
bit.
Input condition/
Display contents
• Enable
• Disable (Default)
Description Select the format of the volume identification information.
Input condition/
Display contents
• Type3 (Default)
• Type1
• Type1 + Type3
Description Select "Default" or "Respond as ETERNUS DX S2" for the product ID that is responded to
the host.
Input condition/
Display contents
• Default
• Respond as ETERNUS DX S2
Description Select the response status when a command to the volume is received while the relevant
volume is reserved by another host.
Input condition/
Display contents
• GOOD (Default)
• RESERVATION CONFLICT
Description Select whether the host is notified ("Enable (Default)") or not notified ("Disable") when
volume mapping is changed.
Input condition/
Display contents
• Enable (Default)
• Disable
Description Select the host is notified ("Enable (Default)") or not notified ("Disable") when the
volume capacity is changed.
Input condition/
Display contents
• Enable (Default)
• Disable