Fujitsu ETERNUS DX60 S3 - Page 875

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
875
● Other Settings
• Command Monitor Time
• Load Balance Response Status
• iSCSI Discovery Reply Mode
• iSCSI Reservation Range
Description Select one of the following options for command timeouts.
Input condition/
Display contents
• Default (25sec.)
Specify 25 seconds.
• Customize
Input a value between 10 and 255 seconds.
Description Select the response status for the load balancing function.
Input condition/
Display contents
• CHECK CONDITION / UNIT ATTENTION (Default)
• BUSY
• TASK SET FULL
This item is only available when "Enable" is selected for "Load Balance" in the subsystem parameter.
Description Select the response mode for iSCSI Discovery requests.
Input condition/
Display contents
• All - Reply All Ports (Default)
Replies to the server with the information for all the iSCSI ports (iSCSI names and IP
addresses).
• Port - Reply Target Port Only
Replies to the server with only the information for the specified iSCSI ports (iSCSI
names and IP addresses).
Description Select the reservation management unit of the iSCSI connection.
Input condition/
Display contents
• Storage System (Default)
The reservation status of volumes is managed for each storage system.
• CA Port
The reservation status of volumes is managed for each CA port.